G-716 Semi-Automatic Cutterhead Grinder

Description

The G-716 Semi-automatic Cutterhead Grinder is used to sharpen 7” to 16” diameter eased edge, milled to pattern, and fingerjoint cutterheads. Worktable traversing is automatic and has adjustable stops. Cutterhead indexing is manual. Each knife is held against a positive stop while being ground.

No Index Plate To Change

No index plate to change when working with heads with different numbers of knives. The use of an index plate assumes that the knives and head separations are uniform throughout, which is often not the case. If the height of the knife is high or low, then the front face of the knife will vary from knife to knife making the task of grinding difficult. The one constant is the back face of the knife, therefore the use of an indexing stop against the back face will provide for accurate indexing regardless of the irregularities in the knives and head slots.

Completely Enclosed Grinding Area

Completely enclosed grinding area provides for a safer and cleaner grinding room. The work area is completely enclosed by a gas spring operated hood. The closed hood provides a tight seal with the coolant recovery tray. Coolant and grinding debris are carried away by the flooded coolant system and returned to the coolant reservoir. Since all the grinding debris and coolant are completely contained within the grinding hood there is no need for a pneumatic airborne particulate collection system.

Head Indexing and Wheel Feed:

• Manual

Minimum / Maximum Diameter Cutterhead:

• 7″ Min./16″Max.

Worktable Feed:

• Air / Oil

Travel (maximum):

• 12″

Adjustable Limits:

• Proximity Switch

Speed:

• Fully Adjustable

Index Method:

• Manual index after each knife is ground

Grinding Spindle:

• 1-1/2 HP Wash Down Duty TEFC Motor
• 3600 RPM, 230/460VAC 3PH, 575VAC 3PH Dual ABEC 7 Precision Bearings, with Sealed Lubrication
• 8″ Diameter Grinding Wheel (9″ Diameter Max.)

Coolant System:

• 15 Gallon Tank with Casters, Sediment Tray
• Full View Sight Glass, 5 GPM Pump (120VAC)
• Wash Down Hose Included

Specifications

• Grinds 7″ to 16″ diameter eased edge, milled to pattern, and finger joint heads
• Automatic traversing worktable with adjustable travel limits
• Manual indexing of knives against a positive stop with grinding position pneumatic brake allowing precision indexing without the need of an index plate
• High precision 1-1/2 HP grinding spindle with sealed lubrication
• Recirculating adjustable flow flooded coolant system with wash down hose
• Fully enclosed grinding chamber with viewing windows and task light
• Grinding wheel feed provides unattended operation